Giuseppe Silano

Giuseppe Silano, Daniel Bonilla Licea, Davide Liuzza et al.

Multi-Rotor Aerial Vehicles (MRAVs) are increasingly used in communication-dependent missions where connectivity loss directly compromises task execution. Existing anti-jamming strategies often decouple motion from communication, overlooking that link quality depends on vehicle attitude and antenna orientation. In coplanar platforms, "tilt-to-translate" maneuvers can inadvertently align antenna nulls with communication partners, causing severe degradation under interference. This paper presents a modular communications-aware control framework that combines a high-level max-min trajectory generator with an actuator-level Nonlinear Model Predictive Controller (NMPC). The trajectory layer optimizes the weakest link under jamming, while the NMPC enforces vehicle dynamics, actuator limits, and antenna-alignment constraints. Antenna directionality is handled geometrically, avoiding explicit radiation-pattern parametrization. The method is evaluated in a relay scenario with an active jammer and compared across coplanar and tilted-propeller architectures. Results show a near two-order-of-magnitude increase in minimum end-to-end capacity, markedly reducing outage events, with moderate average-capacity gains. Tilted platforms preserve feasibility and link quality, whereas coplanar vehicles show recurrent degradation. These findings indicate that full actuation is a key enabler of reliable communications-aware operation under adversarial directional constraints.

Giuseppe Silano, Quentin Sablé, Marco Tognon et al.

This paper presents a sensitivity-based tube Nonlinear Model Predictive Control (NMPC) framework for cooperative aerial chains under bounded parametric uncertainty. We consider a planar two-vehicle chain connected by rigid links, modeled with input-rate actuation to enforce slew-rate and magnitude limits on thrust and torque. Robustness to uncertainty in link mass, length, and inertia is achieved by propagating first-order parametric state sensitivities along the horizon and using them to compute online constraint-tightening margins. We robustify an inter-link separation constraint, implemented via a smooth cosine embedding, and thrust-magnitude bounds. The method is implemented in MATLAB and evaluated with boundary-hugging maneuvers and Monte-Carlo uncertainty sampling. Results show improved constraint margins under uncertainty with tracking performance comparable to nominal NMPC.

Giuseppe Silano, Martin Saska

Close-proximity offshore wind turbine inspection requires strict clearance control around large cylindrical structures under wind and model mismatch. Nominal Nonlinear Model Predictive Control (NMPC) may violate safety constraints when mass, inertia, thrust effectiveness, drag, or wind conditions differ from nominal assumptions. We propose a sensitivity-based robust NMPC for a tilted multirotor that robustifies the tower-clearance constraint via online constraint tightening. First-order parametric state sensitivities provide a structured-uncertainty margin, while bounded gusts are handled by a stage-dependent additive margin. The formulation augments the nominal NMPC with sensitivity propagation and margin evaluation only, leaving the receding-horizon optimization structure unchanged. Monte-Carlo evaluation over 500 uncertainty realizations on a boundary-critical helical inspection trajectory shows that the proposed controller eliminates the clearance violations observed under nominal NMPC at the cost of a moderate increase in solve time.

Giuseppe Silano, Davide Liuzza, Luigi Iannelli et al.

Inspection of power line infrastructures must be periodically conducted by electric companies in order to ensure reliable electric power distribution. Research efforts are focused on automating the power line inspection process by looking for strategies that satisfy different requirements expressed in terms of potential damage and faults detection. This problem comes up with the need of safe planning and control techniques for autonomous robots to perform visual inspection tasks. Such an application becomes even more interesting and of critical importance when considering a multi-robot extension. In this paper, we propose to compute feasible and constrained trajectories for a fleet of quad-rotors leveraging on Signal Temporal Logic (STL) specifications. The planner allows to formulate rather complex missions avoiding obstacles and forbidden areas along the path. Simulations results achieved in MATLAB show the effectiveness of the proposed approach leading the way to experimental tests on the hardware.