Andre Schiele

Manuel Aiple, Andre Schiele, Frans C. T. van der Helm

Variable impedance actuators (VIAs) as tool devices for teleoperation could extend the range of tasks that humans can perform through a teleoperated robot by mimicking the change of upper limb stiffness that humans perform for different tasks, increasing the dynamic range of the robot. This requires appropriate impedance control. Goal of this study is to show the effectiveness of a controller that does not require additional sensors, reducing system complexity and increasing ease of use. The controller should allow to perform precise positioning tasks and dynamic tasks like hammering through teleoperation with a VIA tool device automatically adapting the impedance setting of the VIA. This is achieved by a control law according to the principle "slow-stiff/fast-soft". The controller was tested in a human user study with 24 participants comparing the human-machine performance with the self-adapting controller in a bilateral telemanipulation experiment with two tasks (precision/dynamic) using three impedance settings (high/low/adaptive impedance). The results indicate that the proposed system performs equally well as state of the art stiff teleoperation devices for precision tasks, while having benefits in terms of increased safety and reduced wear for dynamic tasks. This is a step towards teleoperation with a wide dynamic range.

Manuel Aiple, Wouter Gregoor, Andre Schiele

This study is part of research aiming at increasing the range of dynamic tasks for teleoperated field robotics in order to allow operators to use the full range of human motions without being limited by the dynamics of the robotic manipulator. A new variable impedance actuator (VIA) was designed, capable of reproducing motions through teleoperation from precise positioning tasks to highly dynamic tasks. The design requirements based on previous human user studies were a stiffness changing time of 50 ms, a peak output velocity of 20 rad/s and variable damping allowing to suppress undesired oscillations. This is a unique combination of features that was not met by other VIAs. The new design has three motors in parallel configuration: two responsible for changing the VIA's neutral position and effective stiffness through a sliding pivot point lever mechanism, and the third acting as variable damper. A prototype was built and its performance measured with an effective stiffness changing time of 50 to 120 ms for small to large stiffness steps, nominal output velocity of 16 rad/s and a variable damper with a damping torque from 0 to 3 Nm. Its effective stiffness range is 0.2 to 313 Nm/rad. This concludes that the new actuator is particularly suitable for highly dynamic tasks. At the same time, the new actuator is also very versatile, making it especially interesting for teleoperation and human-robot collaboration.

Manuel Aiple, Jan Smisek, Andre Schiele

Series elastic actuators (SEAs) are interesting for usage in harsh environments as they are more robust than rigid actuators. This paper shows how SEAs can be used in teleoperation to increase output velocity in dynamic tasks. A first experiment is presented that tested human ability to achieve higher hammerhead velocities with a flexible hammer than with a rigid hammer, and to evaluate the influence of the resonance frequency. In this experiment, 13 participants executed a hammering task in direct manipulation using flexible hammers in four conditions with resonance frequencies of 3.0 Hz to 9.9 Hz and one condition with a rigid hammer. Then, a second experiment is presented that tested the ability of 32 participants to reproduce the findings of the first experiment in teleoperated manipulation with different feedback conditions: with visual and force feedback, without visual feedback, without force feedback, and with a communication delay of 40 ms. The results indicate that humans can exploit the mechanical resonance of a flexible system to at least double the output velocity without combined force and vision feedback. This is an unexpected result, allowing the design of simpler and more robust teleoperators for dynamic tasks.