Tomoki Anzai

Moju Zhao, Tomoki Anzai, Kei Okada et al.

Two-dimensional multilinked structures can benefit aerial robots in both maneuvering and manipulation because of their deformation ability. However, certain types of singular forms must be avoided during deformation. Hence, an additional 1 Degrees-of-Freedom (DoF) vectorable propeller is employed in this work to overcome singular forms by properly changing the thrust direction. In this paper, we first extend modeling and control methods from our previous works for an under-actuated model whose thrust forces are not unidirectional. We then propose a planning method for the vectoring angles to solve the singularity by maximizing the controllability under arbitrary robot forms. Finally, we demonstrate the feasibility of the proposed methods by experiments where a quad-type model is used to perform trajectory tracking under challenging forms, such as a line-shape form, and the deformation passing these challenging forms.

Moju Zhao, Tomoki Anzai, Fan Shi et al.

Multilinked aerial robot is one of the state-of-the-art works in aerial robotics, which demonstrates the deformability benefiting both maneuvering and manipulation. However, the performance in outdoor physical world has not yet been evaluated because of the weakness in the controllability and the lack of the state estimation for autonomous flight. Thus we adopt tilting propellers to enhance the controllability. The related design, modeling and control method are developed in this work to enable the stable hovering and deformation. Furthermore, the state estimation which involves the time synchronization between sensors and the multilinked kinematics is also presented in this work to enable the fully autonomous flight in the outdoor environment. Various autonomous outdoor experiments, including the fast maneuvering for interception with target, object grasping for delivery, and blanket manipulation for firefighting are performed to evaluate the feasibility and versatility of the proposed robot platform. To the best of our knowledge, this is the first study for the multilinked aerial robot to achieve the fully autonomous flight and the manipulation task in outdoor environment. We also applied our platform in all challenges of the 2020 Mohammed Bin Zayed International Robotics Competition, and ranked third place in Challenge 1 and sixth place in Challenge 3 internationally, demonstrating the reliable flight performance in the fields.

Tomoki Anzai, Kuniyuki Takahashi

For in-hand manipulation, estimation of the object pose inside the hand is one of the important functions to manipulate objects to the target pose. Since in-hand manipulation tends to cause occlusions by the hand or the object itself, image information only is not sufficient for in-hand object pose estimation. Multiple modalities can be used in this case, the advantage is that other modalities can compensate for occlusion, noise, and sensor malfunctions. Even though deciding the utilization rate of a modality (referred to as reliability value) corresponding to the situations is important, the manual design of such models is difficult, especially for various situations. In this paper, we propose deep gated multi-modal learning, which self-determines the reliability value of each modality through end-to-end deep learning. For the experiments, an RGB camera and a GelSight tactile sensor were attached to the parallel gripper of the Sawyer robot, and the object pose changes were estimated during grasping. A total of 15 objects were used in the experiments. In the proposed model, the reliability values of the modalities were determined according to the noise level and failure of each modality, and it was confirmed that the pose change was estimated even for unknown objects.