Bingxu Li

Qiang Zeng, Lipeng Zhu, Yang Li et al.

With the growing integration of renewable energy sources into power grids, the risks of oscillation caused by interactions between grid-tied inverters and the grids are becoming increasingly prominent. Although existing studies have made significant progress in inverter modeling and oscillatory stability analysis, most of them do not sufficiently consider complex mirror frequency coupling effects (MFCE) under unbalanced operating conditions, leading to unreliable models and erroneous stability analysis results. To address this inadequacy, this work develops a novel sequence impedance modeling scheme that can be widely applied to unbalanced operating conditions. In particular, taking a representative type of grid-forming inverter for instance, i.e., droop-controlled inverter (DCI), a single-input single-output sequence impedance modeling method based on harmonic linearization (HL) is proposed to comprehensively model both a given DCI and the connected grid. By accounting for multi-frequency interactions within the DCI, this method captures MFCE and unbalanced factors, leading to a more accurate impedance model. Further, the dominant factors influencing system stability are identified with a combination of normalized sensitivity analysis and proportional weighting. Finally, the detailed impacts of these dominant factors on system stability margin under three typical unbalanced operating conditions are analyzed through the Bode criterion. The effectiveness and reliability of the whole scheme proposed in this work are validated on the constructed grid-connected droop-controlled experimental platform.

Bingxu Li, Fanyong Cheng, Xin Zhang et al.

In practical chiller systems, applying efficient fault diagnosis techniques can significantly reduce energy consumption and improve energy efficiency of buildings. The success of the existing methods for fault diagnosis of chillers relies on the condition that sufficient labeled data are available for training. However, label acquisition is laborious and costly in practice. Usually, the number of labeled data is limited and most data available are unlabeled. The existing methods cannot exploit the information contained in unlabeled data, which significantly limits the improvement of fault diagnosis performance in chiller systems. To make effective use of unlabeled data to further improve fault diagnosis performance and reduce the dependency on labeled data, we proposed a novel semi-supervised data-driven fault diagnosis method for chiller systems based on the semi-generative adversarial network, which incorporates both unlabeled and labeled data into learning process. The semi-generative adversarial network can learn the information of data distribution from unlabeled data and this information can help to significantly improve the diagnostic performance. Experimental results demonstrate the effectiveness of the proposed method. Under the scenario that there are only 80 labeled samples and 16000 unlabeled samples, the proposed method can improve the diagnostic accuracy to 84%, while the supervised baseline methods only reach the accuracy of 65% at most. Besides, the minimal required number of labeled samples can be reduced by about 60% with the proposed method when there are enough unlabeled samples.