Martin Lenz

Sergio Conti, Martin Lenz, Martin Rumpf

Magnetic shape memory alloys are characterized by the coupling between a structural phase transition and magnetic one. This permits to control the shape change via an external magnetic field, at least in single crystals. Composite materials with single-crystalline particles embedded in a softer matrix have been proposed as a way to overcome the blocking of the transformation at grain boundaries. We investigate hysteresis phenomena for small NiMnGa single crystals embedded in a polymer matrix for slowly varying magnetic fields. The evolution of the microstructure is studied within the rate-independent variational framework proposed by Mielke and Theil (1999). The underlying variational model incorporates linearized elasticity, micromagnetism, stray field and a dissipation term proportional to the volume swept by the phase boundary. The time discretization is based on an incremental minimization of the sum of energy and dissipation. A backtracking approach is employed to approximately ensure the global minimality condition. We illustrate and discuss the influence of the particle geometry (volume fraction, shape, arrangement) and the polymer elastic parameters on the observed hysteresis and compare with recent experimental results.

Sergio Conti, Martin Lenz, Matthäus Pawelczyk et al.

Magnetic-shape-memory materials (e.g. specific NiMnGa alloys) react with a large change of shape to the presence of an external magnetic field. As an alternative for the difficult to manifacture single crystal of these alloys we study composite materials in which small magnetic-shape-memory particles are embedded in a polymer matrix. The macroscopic properties of the composite depend strongly on the geometry of the microstructure and on the characteristics of the particles and the polymer. We present a variational model based on micromagnetism and elasticity, and derive via homogenization an effective macroscopic model under the assumption that the microstructure is periodic. We then study numerically the resulting cell problem, and discuss the effect of the microstructure on the macroscopic material behavior. Our results may be used to optimize the shape of the particles and the microstructure.

Sergio Conti, Benedict Geihe, Martin Lenz et al.

The a posteriori analysis of the discretization error and the modeling error is studied for a compliance cost functional in the context of the optimization of composite elastic materials and a two-scale linearized elasticity model. A mechanically simple, parametrized microscopic supporting structure is chosen and the parameters describing the structure are determined minimizing the compliance objective. An a posteriori error estimate is derived which includes the modeling error caused by the replacement of a nested laminate microstructure by this considerably simpler microstructure. Indeed, nested laminates are known to realize the minimal compliance and provide a benchmark for the quality of the microstructures. To estimate the local difference in the compliance functional the dual weighted residual approach is used. Different numerical experiments show that the resulting adaptive scheme leads to simple parametrized microscopic supporting structures that can compete with the optimal nested laminate construction. The derived a posteriori error indicators allow to verify that the suggested simplified microstructures achieve the optimal value of the compliance up to a few percent. Furthermore, it is shown how discretization error and modeling error can be balanced by choosing an optimal level of grid refinement. Our two scale results with a single scale microstructure can provide guidance towards the design of a producible macroscopic fine scale pattern.