Zubair Ahmed Memon

Zubair Ahmed Memon, Mohammad Aslam Uquaili, Mukhtiar Ali Unar

With the development of modern industrial technology a large number of non-linear loads are used in power system, which causes harmonic distortion in the power system. At the same time the power quality and safe operation becomes inferior. Therefore mitigation of harmonics is very necessary under the situation. This paper presents the design of two passive filters to reduce the current harmonics produced by nonlinear loads in industrial power system. Matlab /simulink software has been used for the simulation purpose. The results have been obtained with and without installation of filters and then it is observed that after installation of filters harmonics of the current are reduced and power factor is improved.

Zubair Ahmed Memon, Mohammad Aslam Uqaili, Mukhtiar Ali Unar

Power quality standards (IEEE-519) require to limit the total harmonic distortion within satisfactory range caused by power electronic based devices. Our work deals with the design of hybrid active filter to reduce current perturbations produced by power electronics based devices. The Instantaneous Active and Reactive Power Method (pq) is used to perform the identification of disturbing currents. The pq algorithm creates a reference current, whereas, this reference current is tracked by the current of the voltage source converter. The currents of the voltage source converter are controlled by hysteresis controller. Simulation results showed that the hybrid active filter can compensate the harmonic currents effectively and improve power quality.