Automatic Frame Selection Using MLP Neural Network in Ultrasound Elastography
This work addresses a specific bottleneck in ultrasound elastography for medical imaging, offering an incremental improvement in frame selection to enhance strain image quality.
The paper tackles the problem of selecting optimal ultrasound RF frame pairs for strain imaging by introducing an automatic method using principal component analysis and an MLP classifier, achieving higher quality strain images compared to traditional frame-picking methods with a testing phase that selects frames in only 1.9 ms.
Ultrasound elastography estimates the mechanical properties of the tissue from two Radio-Frequency (RF) frames collected before and after tissue deformation due to an external or internal force. This work focuses on strain imaging in quasi-static elastography, where the tissue undergoes slow deformations and strain images are estimated as a surrogate for elasticity modulus. The quality of the strain image depends heavily on the underlying deformation, and even the best strain estimation algorithms cannot estimate a good strain image if the underlying deformation is not suitable. Herein, we introduce a new method for tracking the RF frames and selecting automatically the best possible pair. We achieve this by decomposing the axial displacement image into a linear combination of principal components (which are calculated offline) multiplied by their corresponding weights. We then use the calculated weights as the input feature vector to a multi-layer perceptron (MLP) classifier. The output is a binary decision, either 1 which refers to good frames, or 0 which refers to bad frames. Our MLP model is trained on in-vivo dataset and tested on different datasets of both in-vivo and phantom data. Results show that by using our technique, we would be able to achieve higher quality strain images compared to the traditional methods of picking up pairs that are 1, 2 or 3 frames apart. The training phase of our algorithm is computationally expensive and takes few hours, but it is only done once. The testing phase chooses the optimal pair of frames in only 1.9 ms.