Sequential Monte Carlo applied to virtual flow meter calibration
This addresses the need for continuous, low-cost calibration of VFMs in oil and gas production, offering an incremental improvement over manual well test methods.
The paper tackles the problem of calibrating virtual flow meters (VFMs) for oil and gas production by using Sequential Monte Carlo (SMC) to infer tuning factors and flow compositions from production separator data, achieving reasonable parameter estimates without relying on well tests in a case with ten wells.
Soft-sensors are gaining popularity due to their ability to provide estimates of key process variables with little intervention required on the asset and at a low cost. In oil and gas production, virtual flow metering (VFM) is a popular soft-sensor that attempts to estimate multiphase flow rates in real time. VFMs are based on models, and these models require calibration. The calibration is highly dependent on the application, both due to the great diversity of the models, and in the available measurements. The most accurate calibration is achieved by careful tuning of the VFM parameters to well tests, but this can be work intensive, and not all wells have frequent well test data available. This paper presents a calibration method based on the measurement provided by the production separator, and the assumption that the observed flow should be equal to the sum of flow rates from each individual well. This allows us to jointly calibrate the VFMs continuously. The method applies Sequential Monte Carlo (SMC) to infer a tuning factor and the flow composition for each well. The method is tested on a case with ten wells, using both synthetic and real data. The results are promising and the method is able to provide reasonable estimates of the parameters without relying on well tests. However, some challenges are identified and discussed, particularly related to the process noise and how to manage varying data quality.