Applying Machine Learning Models on Metrology Data for Predicting Device Electrical Performance
This work addresses overlay control in semiconductor manufacturing to prevent device failures, but it is incremental as it applies existing ML methods to new data.
The study tackled predicting device electrical performance by applying machine learning models to metrology data, demonstrating improved prediction of capacitance results using appropriate models.
Moore Law states that transistor density will double every two years, which is sustained until today due to continuous multi-directional innovations, such as extreme ultraviolet lithography, novel patterning techniques etc., leading the semiconductor industry towards 3nm node and beyond. For any patterning scheme, the most important metric to evaluate the quality of printed patterns is EPE, with overlay being its largest contribution. Overlay errors can lead to fatal failures of IC devices such as short circuits or broken connections in terms of P2P electrical contacts. Therefore, it is essential to develop effective overlay analysis and control techniques to ensure good functionality of fabricated semiconductor devices. In this work we have used an imec N14 BEOL process flow using LELE patterning technique to print metal layers with minimum pitch of 48nm with 193i lithography. FF structures are decomposed into two mask layers (M1A and M1B) and then the LELE flow is carried out to make the final patterns. Since a single M1 layer is decomposed into two masks, control of overlay between the two masks is critical. The goal of this work is of two-fold as, (a) to quantify the impact of overlay on capacitance and (b) to see if we can predict the final capacitance measurements with selected machine learning models at an early stage. To do so, scatterometry spectra are collected on these electrical test structures at (a)post litho, (b)post TiN hardmask etch, and (c)post Cu plating and CMP. Critical Dimension and overlay measurements for line-space pattern are done with SEM post litho, post etch and post Cu CMP. Various machine learning models are applied to do the capacitance prediction with multiple metrology inputs at different steps of wafer processing. Finally, we demonstrate that by using appropriate machine learning models we are able to do better prediction of electrical results.